AM3000 | Synchronous Servomotors
Pole-wound motor series
For the AM3000 servomotors, the stator is not wound outside the housing but inside through a needle winder.
With pole winding, the copper wire is in close contact with the iron core. The wire insulation can be much thinner, since no pressing of the winding head is required. These measures lead to a significant increase in the proportion of “active” copper, which determines the torque value, so that the performance of the AM3000 series is approx. 25…35 % higher. An additional benefit is that the motors are significantly shorter than conventional models.
The AM3000 servomotors are characterised by an extremely low moment of inertia, robust design and high overload capacity. The winding is sealed in order to eliminate air between the individual wires, since the thermal resistance of air is higher than that of epoxy resin. This further increases mechanical resilience, e.g. in case of vibrations.
The AM3000 Synchronous Servomotors are available with eight different flange codes. For each size, once the flange code has been defined, there is scope for variation in the length. The motors are offered with torques between 0.18 and 180 Nm and with a wide range of nominal speeds, so that for each application and gear ratio the motor with the optimum dimensions can be selected.
- rotable plug connectors
- terminal box for AM308x
- tight tolerances: resulting in a highly symmetric structure inside the motor reducing cogging to an absolute minimum
- feedback option: resolver, single-turn and multi-turn absolute encoders
- The motors are available with smooth shaft or with groove and feather key.
- protection class IP 65, shaft feedthrough IP 54, optional IP 65/IP 65
- planetary gear units in different variants
|Motor type||permanent magnet-excited three-phase synchronous motor|
|Insulation class||thermal class F (155 °C)|
|Design form||flange-mounted according to IM B5, IM V1, IM V3|
|Protection class||IP 54, IP 65 (shaft seal)|
|Cooling||convection, permissible ambient temperature 40 °C|
|Coating/surface||matt black coating RAL 9005|
|Temperature sensor||potential-free thermistor|
|Connection method||round plug connector, swivelling, angled|
|Life span||L10h = 20,000 hrs for ball bearings|
|Feather key groove||according to DIN 6885 P1|
|Holding brake backlash-free||spring-loaded brake, suitable only as holding brake|
|Shaft seal||radial shaft seal made of teflon|
|Feedback system option||absolute encoder single- and multi-turn|
|AG2300||High-end gear series for servomotors AM8000 and AM8500|
|AG2400||High-end planetary gear units with output flange|
|AG3210||Economy planetary gear units|
|AG3300||Economy planetary gear units|
|AG3400||Economy planetary gear units with output flange|
|ZK45xx-0xxx, ZK451x-xxxx, ZK453x-0xxx||Supply cables AM3000, AM3500|
|ZS4000-20xx||Plugs for AM3000, AM3500|